Categories

False alarms and system hiccups can be frustrating, and more importantly, could prevent your home’s security from doing its job effectively. Thankfully, most problems, from false alarms to dead batteries, are simple to correct. Explore our tips for troubleshooting your home alarm system in Jonesboro. We’ll help you keep your family members shielded and your system operating properly.

Test Your Home Security System In Jonesboro

One of the most effective ways to troubleshoot your property’s defense is to test it yourself! Modern systems have a test mode so you don’t by accident trigger an emergency response. After moving to test mode, take these steps:

• Arm your system as you would when leaving.
• Open a window or door that has a contact sensor, or test other equipment. Close the window or door once you’re done so it doesn’t trigger the alarm when you reactivate the system.
• Allow the alarm to go off for 60 seconds to make sure a message is dispatched to the security company and an entry is created in the alarm system log.
• Proceed to test sensors as you wish
• Check the alarm’s activity log to verify functionality.

No need to worry, monitoring professionals will know that your alarm system is involved in a test. Just make sure to switch off test mode when complete. It’s smart to test monthly or whenever you change your home’s phone or internet service.

Check The Position And State Of Motion Detectors

Although an integral part of your alarm system, motion sensors are notorious for false alarms. Prevent them with a few basic troubleshooting steps.

• Conduct a visual check. Is there something that could move within the path of the sensor, like a window treatment blown in a breeze?
• Is the sensor clean? Dirt, cobwebs, and debris can result in issues. Make sure the sensor is clean.
• Does the motion detector offer pet immunity you can enable? Some can be set to ignore pets weighing as much as 100 pounds.
• When was the battery last replaced? Low batteries can impact performance or lead to false alarms.
• Is a heat source impairing the sensor? Excessive heat from a fireplace, direct sun, or something else can cause an alarm.

Keep Batteries Ready And Watch Out For Low Battery Warnings

One of the great things about new home security systems is that they’ll alert you when batteries are running low. If your system has a app or control panel, you’ll usually find alerts there. Depending on your system, you could notice an occasional beep when batteries are running out. 

Motion sensors, contact sensors, smoke detectors, and other wireless devices have batteries that will have to be replaced every year or two. It’s wise to keep batteries ready and set a replacement schedule. Some systems also come with a rechargeable backup battery for the central control panel. This backup battery helps keep your system operating if you have a power outage and should recharge once the electricity is working again. If it doesn’t, you will need to replace it.

Troubleshooting Is Simple With ADT Home Security In Jonesboro 

As the top name in home security, ADT builds systems that offer unrivaled protection and functionality. Switching to test mode is simple through the ADT+ app or MyADT.com, and you’ll always be sent alerts when a battery is running low. Get in touch with Secure24 Alarm Systems, an authorized ADT dealer, to find out more and design a system perfect for your Jonesboro home and family. Dial (870) 705-5022 or submit our form today!